facebook
contact

OVERHAUL OF ANCHOR-MOORING WINCH

print
OVERHAUL OF ANCHOR-MOORING WINCH
SCOPE OF WORK:
  • receiving some parts of anchor-mooring winch,
  • quantitative and qualitative control of existing parts,
  • making measurements,
  • designing the missing parts with the entrails of the gearbox,
  • making strength calculations,
  • design documentation,
  • approval of the project by the classifier of IACS (International Association of Classification Societies Ltd.),
  • implementation of the missing pieces created by our documentation,
  • regeneration of brakes - manufacturing and assembling of pins, legalization of holes, legalization of bolts and clamping nuts performance,
  • regeneration of supports - boring of bearings holes, installation of bearings and bushings,
  • regeneration of drums - lathing of breaking surface, boring holes for tubes, fabrication and installation of sleeves,
  • electric motor - complete regeneration in the class IP56,
  • main shaft - manufacturing of new one under the old broken shaft,
  • the gearbox - legalization of contact surfaces, boring holes, making toothwheels and toothshafts with strait and oblique teeth, assembling,
  • execution of missing peripherals - wedges, caps, bushings, spacers, plugs, etc.
  • sandblasting elements, anti-corrosion painting, sea water resistant painting,
  • assembly winch together,
  • supply, installation, on-board testing, the IACS classifier approval.
SOURCE:
  • an incomplete set of parts.
COMMERCIAL PRODUCTS:
  • bearings,
  • seals,
  • seger rings,
  • bronze,
  • steel,
  • oil,
  • paint.
This site uses cookies Look for more Close